Corolla L4-2.4L (2AZ-FE) (2010)
![background image](/toyota/corolla/l4-2.4l_(2az-fe)/Page-1375006.png)
6. REMOVE FRONT AXLE SHAFT NUT LH
(a) Using SST and a hammer, release the staked part of the front axle shaft nut LH.
SST : 09930-00010
NOTICE:
*
Insert SST into the groove with the flat surface facing up.
*
Do not damage the tip of SST using grinders.
*
Completely unstake the staked part before removing the axle hub nut.
*
Do not damage the threads of the drive shaft.
(b) Using a socket wrench (30 mm), remove the front axle shaft nut LH.
7. REMOVE FRONT AXLE SHAFT NUT RH
HINT
Perform the same procedure as for the LH side.
8. SEPARATE FRONT SPEED SENSOR LH (for TMC Made) See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Front Shock Absorber/Removal
9. SEPARATE FRONT SPEED SENSOR RH (for TMC Made)
HINT
Perform the same procedure as for the LH side.
10. SEPARATE FRONT SPEED SENSOR LH (except TMC Made) See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Front Shock Absorber/Removal
11. SEPARATE FRONT SPEED SENSOR RH (except TMC Made)
HINT
Perform the same procedure as for the LH side.
12. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH See: Steering and Suspension/Suspension/Suspension Strut / Shock
Absorber/Service and Repair/Front Shock Absorber/Removal
13. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
14. SEPARATE TIE ROD END SUB-ASSEMBLY LH See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Removal
15. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
16. SEPARATE FRONT LOWER SUSPENSION ARM LH See: Steering and Suspension/Suspension/Ball Joint/Service and Repair/Removal
17. SEPARATE FRONT LOWER SUSPENSION ARM RH
HINT
Perform the same procedure as for the LH side.