Corolla LE Sedan L4-1.8L (1ZZ-FE) (1999)
Ignition Cable: Testing and Inspection
INSPECT HIGH-TENSION CORDS
A. Disconnect the high-tension cords from the spark plugs.
NOTE: Pulling on or bending the cords may damage the conductor inside.
B. Disconnect the high-tension cords from the ignition coils.
1. Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
2. Disconnect the high-tension cord at the grommet.
NOTE:
-
Pulling on or bending the cords may damage the conductor inside.
-
Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
c. Using an ohmmeter, measure the resistance.
Maximum resistance: 25 kOhm per cord
If the resistance is greater than maximum, check the terminals. If necessary, replace the high-tension cord.