Corolla LE Sedan L4-1.8L (1ZZ-FE) (1999)
e. Meet the grooved pin with the notch of the guide hole.
f.
Press the pin with a hammer.
A: 10.0 - 10.4 mm (0.39 - 0.41 inch)
NOTICE: When pressing in the grooved pin, if doing it at the place other than the notch, the shift lever sub-assembly might be damaged.
4. CHECK DETENT ROD OPERATION
5. INSTALL SHIFT LEVER KNOB SLEEVE DETENT ROD
Drive the shift lever knob sleeve to the distance A measured before removal.
6. INSTALL SHIFT LEVER SUB-ASSEMBLY
a. Apply MP grease.
b. Using a brass bar and a hammer, install the control shaft and the shift lever sub-assembly to the shift lever plate.