Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
3. REMOVE RADIATOR ASSEMBLY
a. Disconnect the No. 1 electric cooling fan connector.
b. Disconnect the No. 2 electric cooling fan connector.
c. Disconnect the upper radiator hose.
d. Disconnect the lower radiator hose.
e. Disconnect the radiator reservoir hose.
f.
A/T: Disconnect the 2 oil cooler hoses.
g. Remove the 2 bolts and upper radiator supports.
h. Remove the radiator assembly.
i.
Remove the 2 lower radiator supports.
4. REMOVE ELECTRIC COOLING FAN FROM RADIATOR
Remove the 5 bolts and cooling fan assembly.
DISASSEMBLY
1. REMOVE DRAIN PLUG
a. Remove the drain plug.
c. Remove the O-ring.
2. DENSO Made:
ASSEMBLE SST
SST 09230-01010
a. Install the claw to the overhaul handle, inserting it in the hole in part "A" as shown in the diagram.
b. While gripping the handle, adjust the stopper bolts so that dimension "B" shown in the diagram is 0.2 - 0.3 mm (0.008 - 0.012 inch).
NOTICE: If this adjustment is not done the claw may be damaged.
3. DENSO Made:
UNCAULK LOCK PLATES
Using SST to release the caulking, squeeze the handle until stopped by the stopper bolts.
SST 09230-01010