Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
a. Install the slipper with the bolt.
Torque: 18.5 Nm (189 kg-cm, 14 ft. lbs.)
b. Check that the slipper is held on the cylinder head stopper.
NOTICE: Do not turn the crankshaft.
6. INSTALL CRANK ANGLE SENSOR PLATE
Install the plate with the F mark facing forward.
7. INSTALL TIMING CHAIN COVER AND WATER PUMP
a. Remove any old packing (FIPG) material and be careful not Airdrop any oil on the contact surfaces of the timing chain cover, cylinder head
and cylinder block.
-
Using a razor blade and a gasket scraper, remove all the old packing (FIPG) material from the gasket surfaces and sealing grooves.
-
Thoroughly clean all components to remove all the loose material.
-
Using a non-residue solvent, clean both sealing surfaces.
b. Apply seal packing to the timing chain cover as shown in the illustration.