Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
c. Remove the 2 nuts, bolts and axle carrier.
INSTALLATION
1. INSTALL REAR AXLE CARRIER
a. Install the axle carrier, 2 bolts and nuts to the shock absorber.
Torque: 142 Nm (1,450 kgf-cm, 105 ft. lbs.)
b. Install the bolt, nut and 2 washers and connect the No. 1 and No. 2 lower suspension arm.
Torque: 125 Nm (1,226 kgf-cm, 89 ft. lbs.)
c. Install the bolt and nut, and connect the strut rod to the axle carrier.
Torque: 91 Nm (930 kgf-cm, 67 ft. lbs.)
NOTICE: Tighten the bolt since the nut cannot be rotated.
HINT: After stabilizing the suspension, torque the bolt.
2. INSTALL REAR AXLE HUB
a. Coat a new O-ring with MP grease.
b. Install the parking brake assembly, O-ring, axle hub and 4 bolts.
Torque: 80 Nm (82 kgf-cm, 71 ft. lbs.)
c. Using SST, connect the brake line.
SST 09751-36011
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
3. w/ABS: INSTALL ABS SPEED SENSOR
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
4. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION
5. INSTALL BRAKE DRUM
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
7. BLEED BRAKE SYSTEM
8. CHECK REAR WHEEL ALIGNMENT
9. CHECK ABS SPEED SENSOR SIGNAL