Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
INSTALLATION
NOTE: Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.
1. INSTALL SEATBACK ASSEMBLY
a. Install the seatback assembly with the 4 bolts.
Torque: 43 N.m (440 kgf.cm, 32 ft.lbf)
HINT: Tighten the 4 bolts temporarily, then starting from the bolts on the front right side tighten them completely.
b. Install new hog rings as shown in the illustration.
HINT: When installing hog rings, take care to prevent wrinkles as little as possible.
c. Securely fix the side airbag wire harness to the seat cushion with the wire harness protector.
2. INSTALL INNER FRONT SEAT CUSHION SHIELD
3. INSTALL FRONT SEAT CUSHION SHIELD
4. RECLINING ADJUSTER RELEASE HANDLE
5. INSTALL HEADREST
6. INSTALL FRONT SEAT
NOTE: When mounting the seat to the vehicle, take care not to damage the airbag wire harness.
a. Slide the front seat to the most front position.
NOTE: Make sure that seat adjuster locks.
b. Without holding the seat track handle, mount the seat to the vehicle.