Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
HINT: Match the protrusion of the insulator with the indentation of the housing.
6. Install a new wave washer.
7. Install a new terminal nut.
e. Temporarily install new terminal C kit parts.
1. Install a new terminal insulator (inside).
NOTE: Be careful to install the terminal insulator (inside) in the correct direction.
2. Install a new contact plate.
3. Install a new terminal bolt.
4. Install a new O-ring.
5. Install a new terminal insulator (outside).
6. Install a new wave washer.
7. Install a new terminal nut.
f.
Temporarily tighten the terminal nuts.
g. Tighten terminal nut.
1. Put a wooden block on the contact plate and press it down with a hand press.
Dimensions of wooden block: 20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)
Press force: 981 N (100 kgf, 221 lbf)
Gauge Pressure