Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
/Page-882014.png)
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
10. INSTALL SELF-LOCKING NUT
Using SST, stop the control valve shaft rotating and install a new self-locking nut.
SST 09616-00011
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
11. INSTALL RACK HOUSING CAP
a. Apply sealant to 2 or 3 threads of the rack housing cap.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
b. Install the rack housing cap.
Torque: 59 Nm (600 kgf-cm, 43 ft. lbs.)
c. Using a punch and hammer, stake the 2 parts of the rack housing cap.
12. INSTALL RACK GUIDE SUBASSEMBLY, CONICAL SPRING WASHER, RACK GUIDE SPRING AND RACK GUIDE SPRING CAP
a. Install the rack guide subassembly, conical spring washer and rack guide spring.
b. Apply sealant to 2 or 3 threads of the rack guide spring cap.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
c. Temporarily install the rack guide spring cap.
13. ADJUST TOTAL PRELOAD
a. To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the RH and LH rack ends.
b. Using a hexagon wrench (19 mm), install the rack guide spring cap.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
c. Using a hexagon wrench (19 mm), return the cap 12°.
