Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
Maximum non-alignment: 0.5 mm (0.020 inch)
If alignment is greater than maximum, using SST, adjust the diaphragm spring tip alignment.
SST 09333-00013
3. INSTALL BOOT AND RELEASE FORK SUPPORT TO TRANSAXLE
Torque: 37 Nm (375 kgf-cm, 27 ft. lbs.)
4. APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE GREASE (NLGI NO. 2)
a. Apply molybdenum disulphide lithium base grease to the release fork and release bearing contact point, release fork and push rod contact point
and release fork and pivot point.
b. Apply molybdenum disulphide lithium base grease to the clutch spline.
HINT: Recommended grease part number 08887-01706 (100g).
5. INSTALL RELEASE BEARING AND FORK TO TRANSAXLE
Install the bearing to the release fork, and then install them to the transaxle.
6. INSTALL TRANSAXLE TO ENGINE