Corolla S Sedan L4-1794cc 1.8L DOHC MFI (2001)
a. Using a heat light, heat the body mounting surface to 40 - 60 °C (104 - 140 °F).
NOTE: Do not heat body excessively.
b. Remove protective tape from the body.
c. Wipe off stains with cleaner.
2. CLEAN MOULDING
If reusing the moulding.
a. Using a heat light, heat the moulding to 20 - 30 °C (68 - 86 °F).
NOTE: Do not heat moulding excessively.
b. Remove the adhesive tape from the moulding.
c. Wipe off stains with cleaner.
d. Apply a new adhesive tape to moulding as shown in the illustration.
3. INSTALL MOULDING
a. Using a heat light, heat the body and moulding.
Body: 40 - 60 °C (104 - 140 °F)
Body: 20 - 30 °C (68 - 86 °F)
NOTE: Do not heat moulding excessively.
b. Lift moulding release sheet from the face of moulding.
NOTE:
-
When the moulding release sheet is removed, make sure that no dirt or dust can get onto the uncoated area.
-
Do not apply excessive force onto the moulding, but steady pressure with your thumbs.