Corolla S Sedan L4-1794cc 1.8L DOHC MFI (2001)
c. Push the chain tensioner into the timing chain cover, and install the 2 nuts.
Torque: 9 Nm (92 kgf-cm, 80 inch lbs.)
HINT:
-
In case that the hook is released while pushing in, apply the hook again and push the tensioner in.
-
Pay attention not to catch the O-ring as it is built in the chain tensioner previously.
13. SET CHAIN TENSION
a. Turn the crankshaft counterclockwise, and disconnect the plunger knock pin from the hook.
b. Turn the crankshaft clockwise, and check that the slipper is pushed by the plunger.
HINT: If the plunger does not spring out, press the slipper into the chain tensioner with a screwdriver or your finger so that the hook is
released from the knock pin and the plunger springs out.