Corolla S Sedan L4-1794cc 1.8L DOHC MFI (2001)
a. Remove the 6 bolts, water pump and O-ring.
b. Clean up the engine coolant from the water chamber room.
NOTICE: Do not remove the RH engine mounting bracket and generator when the water pump alone is replaced.
INSPECTION
INSPECT WATER PUMP
a. Visually check the drain hole for coolant leakage.
If leakage is found, replace the water pump.
b. Turn the pulley, and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump.
INSTALLATION
1. INSTALL WATER PUMP
a. Place a new O ring on the timing chain cover.
b. Install the water pump with the 6 bolts.
Torque:
9 Nm (92 kgf-cm, 80 inch lbs.) for Bolt A
11 Nm (113 kgf-cm, 8 ft. lbs.) for Bolt B
HINT: Each bolt length is indicated in the illustration.
A 30 mm (1.18 inch)
B 35 mm (1.38 inch)
2. INSTALL RH ENGINE UNDER COVER
3. INSTALL DRIVE BELT
4. FILL WITH ENGINE COOLANT
5. START ENGINE AND CHECK FOR LEAKS
6. RECHECK ENGINE COOLANT LEVEL