toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine Control Module|Removal and Installation|Page 1609 > < Engine Control Module|Removal and Installation
Page 2
background image

3. REINSTALL ECM

a. Connect the 3 (M/T and 3 A/T) or 4 (4 A/T) ECM connectors.
b. Connect the 5 connectors from connectors on bracket.
c. Connect the heated oxygen sensor (bank 1 sensor 2) connector.
d. Connect the ECM and install the 3 bolts.
e. Install the finish lower center panel. 

Engine Control Module|Removal and Installation|Page 1609 > < Engine Control Module|Removal and Installation