toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Replacement Requirements|Page 4166 > < Replacement Requirements|Page 4164
Page 7
background image

d. Check functioning of the SST.

SST 09082-00700

e. Install the SST.

CAUTION:  Place the disc wheel on the level ground.

1. Connect the connector of SST to the steering wheel pad connector.

SST 09082-00700, 09082-00760

NOTE:  To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock. Also, secure some slack for
the SST wire harness inside the disc wheel.

2. Move the SST to at least 10 m (33 ft) away from the steering wheel pad tied down on the disc wheel.

f.

Cover the steering wheel pad with cardboard box or tires. Covering method using cardboard box:

-

Cover the steering wheel pad with the cardboard box and weight the cardboard box down in 4 places with at least 190 N (20 kg, 44 lb).

Size of cardboard box:
Must exceed the following dimensions: x = 460 mm (18.11 in.)

When dimension of the cardboard box exceeds the diameter of the disc wheel with tire to which the steering wheel pad is tied - 
x = 460 mm (18.11 in.) + width of tire
y = 650 mm (25.59 in.)

NOTE:  If a cardboard box smaller than the specified size is used, the cardboard box will be broken by the shock from the air- bag
deployment.

Replacement Requirements|Page 4166 > < Replacement Requirements|Page 4164