Corolla S Sedan L4-1794cc 1.8L DOHC MFI (2001)
3. REMOVE FRONT SEAT OUTER BELT RETRACTOR.
a. Disconnect the pretensioner connector.
b. LH side only:
Disconnect the retractor switch connector.
c. Remove the 2 bolts and retractor.
4. REMOVE SIDE AIRBAG SENSOR
a. Disconnect the connector.
NOTE: Remove the connector with the sensor assembly installed.
b. Using a torx wrench, remove the 4 screws and side airbag sensor.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace with new ones.
-
Never reuse the side airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL SIDE AIRBAG SENSOR
a. Connect the connector.
NOTE:
-
Connection of the connector is done with the sensor assembly installed.
-
Make sure the sensor assembly is installed to the specified torque.
-
lithe sensor assembly has been dropped, or there are cracks, dents or other defects in the case, the bracket or the connector, replace the
sensor assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installation, shake the sensor assembly to check that there is no looseness