Corolla Sedan L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
![background image](/toyota/corolla_sedan/l4-107.5_1762cc_1.8l_dohc_(7a-fe)/Page-890002.png)
25.
Install hub snap ring in steering knuckle.
26.
Using suitable tool, drive a new oil seal and dust deflector (if equipped) into steering knuckle surface, then apply suitable grease to oil seal lip and
axle shaft.
27.
If removed, install ball joint.
28.
Reverse procedure to install, torque two strut-to-steering knuckle attaching nuts and bolts, steering knuckle-to-lower suspension arm attaching
bolts, tie rod end attaching nut and bearing locknut to specifications.