Corolla Sedan L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
Clutch Master Cylinder: Service and Repair
Replacement
REMOVAL
1. Remove brake booster.
2. Draw out fluid with syringe.
3. Disconnect clutch line.
Using Special Service Tool (SST) 09023-00100 or equivalent, disconnect the clutch line.
Use a container to catch the fluid.
Torque: 15 Nm (11 ft. lbs.).
4. Remove lower finish panel.
5. Remove duct heater to resister No.2.
6. Remove clip and pin.
7. Remove two mounting nuts and pull out master cylinder.
Torque: 12 Nm (108 inch lbs.).
INSTALLATION
Installation is in the reverse order of removal.
INSTALLATION NOTE: After installation, bleed system and adjust clutch pedal.