Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-682004.png)
Using a dial indicator, measure the inside diameter of the direct clutch bushing.
Maximum inside diameter: 48.27 mm (1.9004 in.)
If the inside diameter is greater than the maximum, replace the direct clutch.
DIRECT CLUTCH ASSEMBLY
1. INSTALL CLUTCH PISTON IN DIRECT CLUTCH DRUM
a. Install new O-rings to the piston. Coat the O-rings with ATF.
b. Being careful not to damage the O-rings, press the piston into the drum with the cup side up.
2. INSTALL PISTON RETURN SPRING
a. Place the return spring and snap ring onto the piston.
b. Place SST on the return spring, and compress the return spring with a shop press.
SST 09350-32014 (09351-32070)
c. Install the snap ring with the snap ring pliers. Be sure the end gap of snap ring is not aligned with the spring retainer claw.
3. INSTALL PLATES, DISCS AND FLANGE
a. Install plates and discs in order.
P = Plate D = Disc F = Flange
P - D - P - D - P - D - F
b. Install the flange with the flat end facing downward.
