Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
Fig. 14 Differential Pinion Washer Identification. Corolla AWD
15.
If tooth contact is incorrect, replace washer between rear bearing and pinion with one that will provide proper tooth contact, Fig. 14. If pinion
depth adjustment is necessary, repeat steps 7-15 until proper tooth contact is obtained.
16.
Install selected washer and press rear bearing onto pinion, then mount pinion assembly in carrier.
17.
Install new bearing spacer, front bearing and oil slinger on pinion.
Fig. 11 Pinion Seal Installation
18.
Using a suitable driver, Fig. 11, install pinion seal to the following depth:
a. 6 inch, recessed 0.039 inch.
b. 6.38 inch, recessed up to 0.02 inch.
c. 6.7 inch, recessed 0.16 inch.
Fig. 5 Companion Flange Replacement
19.
Install companion flange with SST 09557-22022, Fig. 5.