Cressida L6-2759cc 2.8L DOHC (5M-GE) (1988)
4.
Reverse procedure to install.
WINDSHIELD WIPER/WASHER SWITCH
1.
Disconnect battery ground cable, then remove steering wheel and upper and lower steering column covers.
2.
Disconnect wire terminal from horn contact (if equipped).
3.
Disconnect windshield wiper/washer switch connector, then using a small screwdriver, disengage windshield wiper/washer switch wiring from
combination switch connector. Note position of wires.
4.
Remove screw, clamp and windshield wiper/washer switch assembly.
5.
Reverse procedure to install.