Cressida Sedan L6-2759cc 2.8L DOHC (5M-GE) (1986)
Brake Pedal Assy: Technical Service Bulletins
Brakes - Pedal Height Adjustment Changed
REFERENCE BRAKES
NUMBER
007
DATE
08-31-90
MODEL
MX83E
TITLE ADJUSTMENT METHOD OF BRAKE PEDAL HEIGHT
The brake pedal height adjustment method and brake pedal freeplay specification has been changed.
PRODUCTION EFFECTIVE:
VIN
P/D
JT2MX83E-L0037048
8/89
REPAIR MANUAL EFFECTED:
Pub. Name
Pub. No.
Page
Cressida Repair Manual
RM152U
BR-6
FIG. 1
CHECK AND ADJUSTMENT OF THE BRAKE PEDAL HEIGHT
1.
CHECK THAT PEDAL HEIGHT IS CORRECT, AS SHOWN IN FIG. 1:
Pedal height from intended face of asphalt sheet:
157 - 167 mm (6.18 - 6.57 inches)
2.
IF NECESSARY, ADJUST PEDAL HEIGHT
(a)
Remove the instrument lower finish panel and air duct.
(b)
Disconnect the connector from the stop light switch.
(c)
Loosen the stop light switch lock nut and remove the stop light switch.
(d)
Loosen the push rod lock nut.
(e)
Adjust the pedal height by turning the pedal push rod.
(f)
Tighten the push rod lock nut.
Torgue:
260 kg-cm ( 19 ft.lb., 25 N-m )
(g)
Install the stop light switch and turn it until clearance (A) is zero.
(h)
Return the stop light switch one turn.
(i)
Check the clearance (A) between the stop light switch and the pedal (refer to Fig. 1).