FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Repair/Removal
42. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal
43. REMOVE INSTRUMENT PANEL FINISH PANEL END LH See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
44. REMOVE IGNITION SWITCH LOCK CYLINDER AND KEY SET
(a) Turn the ignition switch lock cylinder to the ACC position.
(b) Push down the stop pin with a screwdriver and pull out the ignition switch lock cylinder.
45. REMOVE KEY INTER LOCK SOLENOID (for Automatic Transmission)
(a) Disconnect the clamp from the steering column bracket upper.
(b) Remove the 2 screws and the key inter lock solenoid.
46. REMOVE UNLOCK WARNING SWITCH
(a) Disconnect the connector.
(b) Remove the unlock warning switch toward the rear of the vehicle by pushing up the center part.
Installation
DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION
INSTALLATION
1. INSTALL UNLOCK WARNING SWITCH
(a) Install the unlock warning switch onto the steering column bracket upper.
(b) Connect the connector.
2. INSTALL KEY INTER LOCK SOLENOID (for Automatic Transmission)