FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Mud Flap: Service and Repair
Removal
EXTERIOR: FENDER PANEL MUDGUARD: REMOVAL
REMOVAL
HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Back Sonar)
2. REMOVE REAR BUMPER COVER See: Bumper/Rear Bumper/Service and Repair/Removal
3. REMOVE FRONT FENDER MUDGUARD
(a) Using a clip remover, remove the clip.
(b) Remove the 5 screws and the front fender mudguard.
4. REMOVE QUARTER PANEL MUDGUARD
(a) Using a clip remover, remove the clip.
(b) Remove the 4 screws and the quarter panel mudguard.