FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Hydraulic Brake Booster: Service and Repair
Removal
BRAKE: HYDRAULIC BRAKE BOOSTER: REMOVAL
REMOVAL
NOTICE:
-
Before starting the work, make sure that the ignition switch is OFF and depress the brake pedal more than 20 times.
-
As high pressure is applied to the brake actuator No. 1 tube, never deform it.
-
Do not turn the ignition switch to ON until the work is completed.
HINT: When the pressure in the accumulator is released, the reaction force becomes lighter and the stroke becomes longer.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with a painted surface.
3. REMOVE FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
4. REMOVE FRONT FLOOR FOOTREST See: Body and Frame/Interior Moulding / Trim/Foot Rest/Service and Repair/Removal
5. REMOVE FOOTREST CLIP See: Body and Frame/Interior Moulding / Trim/Foot Rest/Service and Repair/Removal
6. REMOVE COWL SIDE TRIM BOARD See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
7. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
8. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
9. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
10. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
11. SEPARATE MASTER CYLINDER PUSH ROD CLEVIS See: Brake Pedal Assy/Service and Repair/Removal
12. REMOVE HYDRAULIC BRAKE BOOSTER
(a) Disconnect the 3 connectors from the hydraulic brake booster.