FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Yaw Rate Sensor: Service and Repair
Removal
BRAKE CONTROL: YAW RATE AND DECELERATION SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD) See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
6. REMOVE YAW RATE AND DECELERATION SENSOR
(a) Disconnect the yaw rate and deceleration sensor connector.
(b) Remove the 2 bolts and remove the yaw rate and deceleration sensor.