FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Thermostat: Service and Repair
Installation
1GR-FE COOLING: THERMOSTAT: INSTALLATION
INSTALLATION
1. INSTALL WATER INLET WITH THERMOSTAT
(a) Install a new gasket onto the water inlet with thermostat.
(b) Install the water inlet with thermostat with the 3 nuts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
2. CONNECT NO. 2 RADIATOR HOSE
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
4. ADD ENGINE COOLANT See: Coolant/Service and Repair
5. CHECK FOR ENGINE COOLANT LEAKAGE See: Coolant/Service and Repair
6. INSTALL V-BANK COVER See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and Repair/Installation