FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Hazard Warning Switch: Component Tests and General Diagnostics
LIGHTING: HAZARD WARNING SWITCH:
INSPECTION
1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY
(a) Check the resistance of the hazard warning switch.
(1) Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the integration control and panel.
(b) Check the illumination operation.
(1) Connect the positive (+) battery lead to terminals 1 and 2, and the negative (-) battery lead to terminal 20, then check that the illumination
illuminates.
Standard:
Illumination illuminates.
If the illumination does not illuminate, replace the integration control and panel.