FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
(b) Connect the connector, harness clamp and access panel lock control cable.
2. INSTALL CENTER PILLAR UPPER GARNISH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly
3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly
4. INSTALL NO. 1 CUP HOLDER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Reassembly
5. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly
6. INSTALL LAP BELT OUTER ANCHOR COVER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly
7. INSTALL ACCESS PANEL REAR WEATHERSTRIP See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Reassembly
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)