FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
HINT:
-
Use the same procedure for both the RH and LH sides.
-
The procedure described below is for the RH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE ACCESS PANEL REAR WEATHERSTRIP See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
3. REMOVE LAP BELT OUTER ANCHOR COVER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
5. REMOVE NO. 1 CUP HOLDER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Disassembly
6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
7. REMOVE ACCESS PANEL LOWER LOCK ASSEMBLY
(a) Disconnect the connector, connector clamp and access panel lock control cable.
(b) Using "Torx" socket wrench T30, remove the 3 screws.
(c) Remove the access panel lower lock by sliding it upward.
Installation
LIGHTING: REAR DOOR COURTESY SWITCH (for Lower Side): INSTALLATION
INSTALLATION
1. INSTALL ACCESS PANEL LOWER LOCK ASSEMBLY
(a) Install the access panel lower lock onto the rear door.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
(b) Connect the connector, connector clamp and access panel lock control cable.