FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Turn Signal Flasher: Testing and Inspection
LIGHTING: TURN SIGNAL FLASHER ASSEMBLY:
ON-VEHICLE INSPECTION
1. INSPECT TURN SIGNAL FLASHER CIRCUIT
(a) Check the power source circuit and ground circuit.
(1) Disconnect the turn signal flasher connector.
(2) Measure the voltage and check the results in accordance with the value(s) in the table below.
Standard Voltage:
If the result is not as specified, there may be a malfunction on the wire harness side.
(3) Measure the resistance and check the result in accordance with the value(s) in the table below.
Standard Resistance:
If the result is not as specified, there may be a malfunction on the wire harness side.
(b) Check the output operation signal.
(1) Reconnect the turn signal flasher connector.
(2) Measure the voltage and check the results in accordance with the value(s) in the table below.
Standard Voltage: