FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Tire Pressure Module: Service and Repair
Installation
TIRE AND WHEEL: TIRE PRESSURE WARNING ECU: INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Install the tire pressure warning ECU with the nut.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(b) Connect the tire pressure warning ECU connector.
2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Installation
3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
4. REGISTRATION TRANSMITTED ID See: Tire Monitoring System/Testing and Inspection/Programming and Relearning
5. INSPECT TIRE PRESSURE WARNING SYSTEM See: Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Test Mode Procedure