FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
7. CHECK CAN BUS LINES FOR SHORT CIRCUIT (STEERING ANGLE SENSOR BRANCH WIRE)
(a) Turn the ignition switch OFF.
(b) Disconnect the E65 steering angle sensor branch wire connector.
NOTICE:
-
Before disconnecting the connector, make a note of where it is connected.
-
Reconnect the connector to its original position.
(c) Measure the resistance.
Result:
OK -- CONNECT CONNECTOR
NG -- Continue to next step.
8. CONNECT CONNECTOR
(a) Reconnect the steering angle sensor branch wire connector.
NEXT -- Continue to next step.
9. CHECK CAN BUS LINES FOR SHORT CIRCUIT (ECM MAIN WIRE)
(a) Turn the ignition switch OFF.
(b) Disconnect the E62 ECM main wire connector.
NOTICE:
-
Before disconnecting the connector, make a note of where it is connected.
-
Reconnect the connector to its original position.