FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Engine Control Module: Component Tests and General Diagnostics
1GR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: ECM Power Source Circuit
ECM Power Source Circuit
DESCRIPTION
When the ignition switch is turned ON, the battery voltage is applied to terminal IGSW of the ECM. The ECM MREL output signal causes a current to
flow to the coil, closing the contacts of the EFI relay and supplying power to terminal +B of the ECM.
If the ignition switch is turned OFF, the ECM holds the EFI relay ON for a maximum of 2 seconds to allow for the initial setting of the throttle valve.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. INSPECT ECM (+B VOLTAGE)
(a) Turn the ignition switch ON.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)