FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
CAUTION:
-
Wear protective gloves when removing the sensor.
-
The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
-
Confirm that the exhaust pipe assembly has cooled down before removing it.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE AIR FUEL RATIO SENSOR
(a) Remove the 3 bolts, then remove the No. 2 exhaust manifold stay. (for LH Bank)
(b) Disconnect the 2 air fuel ratio sensor connectors.
(c) Using SST, remove the 2 air fuel ratio sensors from the exhaust manifold.
SST: 09224-00010
Installation
1GR-FE EMISSION CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION
INSTALLATION
1. INSTALL AIR FUEL RATIO SENSOR
(a) Using SST, install the 2 air fuel ratio sensors onto the exhaust manifold.
SST: 09224-00010
Torque: 44 Nm (449 kgf-cm, 33 ft-lbf)
(b) Connect the 2 air fuel ratio sensor connectors.