FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Evaporative Emission Control Canister: Service and Repair
Removal
1GR-FE EMISSION CONTROL: CANISTER: REMOVAL
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
See: Fuel Delivery and Air Induction/Service Precautions/Fuel System Precautions
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE CHARCOAL CANISTER ASSEMBLY
(a) Disconnect the fuel tank breather tube from the fuel tank.
(1) Push the connector deep inside.
(2) Pinch portion A, as shown in the illustration.
(3) Pull out the connector.
NOTICE:
-
Remove any dirt and foreign objects from the fuel tank vent hose connector before performing the work.
-
Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tank vent hose connector has the O-ring that
seals the pipe.
-
Perform the work by hand. Do not use any tools.
-
Do not forcibly bend, twist or turn the nylon tube.
-
Protect the disconnected part by covering it with a vinyl bag after disconnecting the fuel tank vent hose.
-
If the fuel vent connector and pipe are stuck, push and pull them to release.
(b) Disconnect the No. 2 canister outlet hose sub-assembly.
(1) Push the connector deep inside.
(2) Pinch portion A, as shown in the illustration.
(3) Pull out the connector.
NOTICE:
-
Remove any dirt and foreign objects from the fuel tank vent hose connector before performing the work.
-
Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tank vent hose connector has the O-ring that
seals the pipe.
-
Perform the work by hand. Do not use any tools.
-
Do not forcibly bend, twist or turn the nylon tube.
-
Protect the disconnected part by covering it with a vinyl bag after disconnecting the fuel tank vent hose.
-
If the fuel vent connector and pipe are stuck, push and pull them to release.