FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
/Page-951001.png)
Variable Induction Control Valve: Testing and Inspection
1GR-FE INTAKE: VACUUM SWITCHING VALVE:
INSPECTION
1. INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance between the terminals.
Standard resistance:
If the result is not as specified, replace the vacuum switching valve No. 1.
(b) Check the vacuum switching valve No. 1 for ground.
(1) Using an ohmmeter, measure the resistance between each terminal and the body.
Standard resistance:
If the result is not as specified, replace the vacuum switching valve No. 1.
(c) Check the operation.
(1) Check that air does not flow from port E to port F.
If the operation is not as specified, replace the vacuum switching valve No. 1.
(2) Apply battery voltage across the terminals.
(3) Check that air flows from port E to port F.
If the operation is not as specified, replace the vacuum switching valve No. 1.