FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Crankshaft Position Sensor: Service and Repair
Removal
1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FAN
Refer to the procedures up to "REMOVE FAN " See: Engine, Cooling and Exhaust/Cooling System/Radiator Cooling Fan/Service and Repair/Removal.
3. REMOVE GENERATOR ASSEMBLY
Refer to the procedures up to "REMOVE GENERATOR ASSEMBLY" See: Starting and Charging/Charging System/Alternator/Service and
Repair/Removal
4. SEPARATE COOLER COMPRESSOR ASSEMBLY
(a) Remove the bolt, then separate the suction hose sub-assembly.
(b) Disconnect the cooler compressor assembly connector.
(c) Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
5. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the crankshaft position sensor connector.
(b) Remove the bolt, then remove the crankshaft position sensor.