FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Crankshaft Position Sensor: Service and Repair
Installation
1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
(b) Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7.4 ft-lbf)
(c) Connect the crankshaft position sensor connector.
2. INSTALL COOLER COMPRESSOR ASSEMBLY
(a) Install the cooler compressor assembly with the 4 bolts.
Torque: 24.5 Nm (250 kgf-cm, 18 ft-lbf)
(b) Connect the cooler compressor assembly connector.
(c) Install the suction hose sub-assembly with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 in-lbf)
3. INSTALL GENERATOR ASSEMBLY
Refer to the procedures up to "INSTALL GENERATOR ASSEMBLY" See: Starting and Charging/Charging System/Alternator/Service and
Repair/Installation
4. INSTALL FAN
Refer to the procedures up to "INSTALL FAN" See: Engine, Cooling and Exhaust/Cooling System/Radiator Cooling Fan/Service and
Repair/Installation.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)