FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
(b) Remove 3 bolts and the center airbag sensor assembly.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION
INSTALLATION
1. PRECAUTION
CAUTION: Read "PRECAUTION" thoroughly before servicing See: Service Precautions.
2. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is turned to OFF.
(b) Check that the negative (-) battery terminal is disconnected.
NOTE: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
(c) Temporarily install the center airbag sensor assembly with the 3 bolts.
-
If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector,
replace it with a new one.
-
When installing the center airbag sensor assembly, make sure that the SRS wiring does not interfere with any other parts and that it is not
pinched between other parts.
(d) Tighten the 3 bolts to the specified torque.
Torque: 17.5 Nm (179 kgf-cm, 13 ft-lbf)
(e) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
(f) Connect the holder (with connectors) to the center airbag sensor assembly.
(g) Check that the water-proof sheet is properly set.
3. INSTALL INSTRUMENT LOWER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
4. INSTALL CONSOLE UPPER PANEL NO.1 GARNISH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Installation
5. INSTALL FRONT CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
6. INSTALL BOX BOTTOM MAT See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Installation
7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation