FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Impact Sensor: Testing and Inspection
Center Airbag Sensor Assembly
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY:
ON-VEHICLE INSPECTION
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
3. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)
(a) Replace the center airbag sensor assembly.
CAUTION: Be sure to follow the correct removal and installation procedures. See: Service and Repair/Center Airbag Sensor Assembly
HINT: The center airbag sensor assembly should be replaced after any of the airbags has deployed, as it has been subjected to the impact.