FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
HINT:
-
Use the same procedure for both the RH and LH sides.
-
The procedure described below is for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE ACCESS PANEL REAR WEATHERSTRIP See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
3. REMOVE LAP BELT OUTER ANCHOR COVER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
5. REMOVE NO. 1 CUP HOLDER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Disassembly
6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
7. REMOVE CENTER PILLAR UPPER GARNISH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
8. REMOVE ACCESS PANEL UPPER LOCK ASSEMBLY
(a) Disconnect the connector, harness clamp and the access panel lock control cable.
(b) Remove the 3 bolts, then remove the access panel upper lock.
Installation
LIGHTING: REAR DOOR COURTESY SWITCH (for Upper Side): INSTALLATION
INSTALLATION
1. INSTALL ACCESS PANEL UPPER LOCK ASSEMBLY
(a) Install the access panel upper lock with the 3 bolts.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)