FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Tire Pressure Sensor: Service and Repair
Removal
TIRE AND WHEEL: TIRE PRESSURE WARNING VALVE AND TRANSMITTER: REMOVAL
REMOVAL
1. REMOVE FRONT TIRE
2. REMOVE REAR TIRE
3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) Remove the valve core and cap, and release air from the tire.
(b) After ensuring that air is sufficiently released, remove the nut and washer that are used to fix the tire pressure warning valve and transmitter
and drop the sensor inside the tire.
HINT: Keep the removed cap, valve core, nut and washer.
(c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of the tire remover.
NOTE: Be careful not to damage the tire pressure warning valve and transmitter because of interference between the sensor and tire bead.
(d) Remove the bead on the upper side.
(e) Take out the sensor from the tire and remove the bead on the lower side.
(f) Remove the inner grommet from the tire pressure warning valve and transmitter.
HINT: Check that there are no cracks or damage to the grommet. If any damage is found, replace the grommet together with the washer and
nut.