FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
(a) Using a hammer and chisel, raise the flange of the bushing diagonally as shown in the illustration.
(b) Using SST and a press, remove the upper arm bush (front side).
SST: 09613-26010
SST: 09710-22021
09710-01031
SST: 09950-00020
(c) The removal procedure for the rear side is the same as that for the front side.
Reassembly
SUSPENSION: FRONT UPPER SUSPENSION ARM: REASSEMBLY
REASSEMBLY
1. INSTALL FRONT SUSPENSION UPPER ARM BUSH
(a) Using SST and a press, install a new upper arm bush (front side).
SST: 09710-26010
09710-05061
(b) The installation procedure for the rear side is the same as that for the front side.
Installation
SUSPENSION: FRONT UPPER SUSPENSION ARM: INSTALLATION
INSTALLATION
1. TEMPORARILY TIGHTEN FRONT UPPER SUSPENSION ARM
(a) Install the upper arm and temporarily tighten the bolt, 2 washers and nut.
(b) Install the bracket with the bolt.
Torque: 5.8 Nm (59 kgf-cm, 51 in-lbf)