FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
1. REMOVE REAR WHEEL
2. REMOVE REAR STABILIZER LINK ASSEMBLY
(a) Remove the nut and separate the stabilizer link.
HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
(b) While holding the stabilizer link with a spanner, remove the nut.
(c) Remove the 2 No. 1 retainers, 2 cushions, No. 2 retainer and stabilizer link.
(d) The removal procedure for the RH side is the same as that for the LH side.
3. REMOVE REAR STABILIZER BAR
(a) Remove the 4 bolts, stabilizer bracket cover and stabilizer bar.
4. REMOVE REAR STABILIZER BUSH
(a) Remove the stabilizer bush from the stabilizer bar.
Installation
SUSPENSION: REAR STABILIZER BAR: INSTALLATION
INSTALLATION
1. INSTALL REAR STABILIZER BUSH
(a) Install the 2 stabilizer bushes onto the stabilizer bar.
HINT: Install the stabilizer bush onto the outer side of the bush stopper on the stabilizer bar.
2. INSTALL REAR STABILIZER BAR