FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
(d) Set the wheel disc to the mounting machine and install the lower tire bead. Position the main body of the sensor as in the shaded area shown in
the illustration.
NOTE: If the sensor is positioned outside this area, it generates interference with the tire bead, causing possible damage to the sensor.
(e) Install the upper bead.
NOTE: Make sure that the tire bead and tool do not interfere with the main body of the sensor and that the sensor is not clamped by the bead.
2. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
3. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
4. INSPECT TIRE
See: Testing and Inspection/Component Tests and General Diagnostics
5. REGISTRATION TRANSMITTED ID
See: Testing and Inspection/Programming and Relearning
6. INSPECT TIRE PRESSURE WARNING SYSTEM
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure