FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with painted surfaces.
3. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY See: Wheel Hub/Service and Repair/Removal
4. REMOVE FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Removal
5. REMOVE FRONT AXLE HUB BOLT
(a) Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.
SST: 09650-17011
Installation
AXLE: FRONT AXLE HUB BOLT: INSTALLATION
INSTALLATION
1. INSTALL FRONT AXLE HUB BOLT
(a) Install the washer and the nut onto a new hub bolt, as shown in the illustration.
(b) Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.
2. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Installation
3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY See: Wheel Hub/Service and Repair/Installation
4. INSTALL FRONT WHEEL
Torque: 112 Nm (1,137 kgf-cm, 82 ft-lbf)
5. FILL RESERVOIR WITH BRAKE FLUID See: Brakes and Traction Control/Brake Bleeding/Service and Repair
6. BLEED BRAKE LINE See: Brakes and Traction Control/Brake Bleeding/Service and Repair
7. CHECK FLUID LEVEL IN RESERVOIR See: Brakes and Traction Control/Brake Bleeding/Service and Repair
8. CHECK FOR BRAKE FLUID LEAKAGE