FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT ARMREST BASE UPPER PANEL
(a) Disengage the 3 claws and clip and remove the front armrest base upper panel.
(b) Disconnect the connector.
3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
(a) Remove the 3 screws and the power window regulator master switch.
Installation
WINDSHIELD / WINDOWGLASS: POWER WINDOW MASTER SWITCH: INSTALLATION
INSTALLATION
1. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
(a) Install the power window regulator master switch with the 3 screws.
2. INSTALL FRONT ARMREST BASE UPPER PANEL
(a) Connect the connector.
(b) Engage the 3 claws and clip and install the front armrest base upper panel.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)