FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
/Page-2214002.png)
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE BACK DOOR TRIM COVER RH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
3. REMOVE BACK DOOR TRIM COVER LH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
4. REMOVE DOOR TRIM RETAINER CAP See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
5. REMOVE BACK DOOR TRIM BOARD See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
6. REMOVE BACK DOOR SERVICE HOLE COVER See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Disassembly
7. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
(a) Open the rear wiper arm head cap.
(b) Remove the nut and the rear wiper arm and blade.
8. REMOVE REAR WIPER MOTOR
(a) Disconnect the connector.
(b) Remove 3 bolts and the rear wiper motor.
Installation
WIPER AND WASHER: REAR WIPER MOTOR: INSTALLATION
INSTALLATION
1. INSTALL REAR WIPER MOTOR