FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
![background image](/toyota/fj_cruiser_4wd/v6-4.0l_(1gr-fe)/Page-1443030.png)
c. Install the 3 clamps and the connector.
d. Install the clamp.
e. Connect the 2 connectors.
f.
Insert the wire harness into the 2 clamps.
2. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL SUB-ASSEMBLY
3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
4. INSTALL INSTRUMENT PANEL REGISTER ASSEMBLY
5. INSTALL ROOM LIGHT ASSEMBLY
HINT: The procedure described below is for the front side. Use the same procedure for both the front and rear sides, unless otherwise specified.